Qingdao Yonghui Packaging Machinery Co.,Ltd
To Be Irreplaceable, Be Unique.
Add to Cart
Tungsten Carbide Corrugating Rolls For Taiwan Yueli Single Facer
1. Advanced Equipments
♦ Harden the tungsten carbide corrugating roll surface, make the hardness more than HRC58, harden depth 8-12mm.
♦ Special grinding machine for corrugating rolls with Siemens control system.
♦ Sand blasting make a rough surface of the roll. It's to increase adhesion of TC powder.
♦ American Praxair JP8000 HVOF tungsten carbide plating machine is the most advanced in the world.
♦ Smooth surface can extend the life span of tungsten carbide corrugating rolls.
High precison grinding machine with Siemens CNC system.
Sand blasting machine
Polishing machine
2. Flute profile
The most important parameter is the flute profile. To design the flute profile, we must know the corrugated paper gsm, speed, flute height, correct diameter and other requirement such as good FCT, saving paper, etc. Our engineer has rich experience of designing flute profile. Without good design, many problems will appear, such as flute paper broken, low speed, collapsed flute, high-low flute and so on.
The following table is just for a reference.
| Flute | Profile | Height(mm) | Pitch(mm) | Flutes/300mm | T.U.R |
| A | UV | 4.5-5.0 | 8.0-9.5 | 34±3 | 1.45-1.52 |
| C | UV | 3.5-4.0 | 6.8-7.9 | 41±3 | 1.37-1.47 |
| B | UV | 2.5-3.0 | 5.5-6.5 | 50±4 | 1.33-1.41 |
| E | UV | 1.1-2.0 | 3.0-3.5 | 93±6 | 1.24-1.36 |
| F | UV | 0.8-1.0 | 2.2-3.2 | 115±20 | 1.19-1.25 |
| G | UV | 0.6-0.8 | 1.8-2.8 | 136±20 | 1.15-1.20 |
| N | UV | 0.4-0.6 | 1.2-2.2 | 193±55 | 1.10-1.15 |
| Others | UV | Customized | Design | Design | Design |
3. Package
4. Precision index of corrugating rolls
| Item | Index |
| Gear teeth height limits of deviation | ≤ 0.01mm |
| Addendum circle run out tolerance | ≤ 0.02mm |
| Gear teeth width limits of deviations | ≤ 0.015mm |
| Tooth profile limits of deviations | ≤ 0.01mm |
| Gear lateral face counter shaft parallelism | ≤ 0.01mm |
| Tip cylinder element linear | ≤ 0.01mm |
| Gear teeth division limits of deviations | ±10" |
| Smooth finish | Ra<0.6µm |